aevit VIC 2.0 설치 및 운영 매뉴얼 - 페이지 11

{카테고리_이름} aevit VIC 2.0에 대한 설치 및 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. aevit VIC 2.0 17 페이지. Voice interactive controls

4. TrAININg

EMC recommends that the Certified Technician complete the entire training process so they are famil-

iar with training VIC 2.0. This will speed up time spent with training the client.

This section assumes that the AEVIT 2.0 system has been properly installed, is functioning properly

and the initial bootup procedure has been completed. See the Operation and Programming Manual

for more information.

VIC 2.0 has two parts to the training. Part 1, Training, is to record and train the words and Part 2, rec-

ognition, is to test the recognition of the words trained during Part 1.

In order to begin training you MUST have:

•

All vehicle doors & windows shut

•

AEVIT 2.0 system awake

•

Vehicle's ignition OFF

•

Everything as

The AEVIT 2.0 system will stay awake for 30 minutes when the vehicle's ignition is not on but the system is

awake. The entire training processes takes approximately 15 minutes so there is plenty enough time to com-

plete the training before AEVIT 2.0 automatically goes to sleep. The more quiet the environment is, the more

success you will have training VIC 2.0.

During the training of VIC 2.0 it is important to:

•

Make sure the microphone is positioned correctly. The WHITE dot on the microphone should be

pointed toward the client as shown in the figures below.

•

Speak loudly and clearly

•

During Part 2,

in Part 1, Training.

•

Wait for the "beep".

For best training and recognition results, wait approximately (1) second after the "beep" to be-

gin speaking.

QUIeT as possible

CORRECT

WHITE DOT SHOULD

POINT TOWARDS CLIENT

recognition, repeat the command as close as possible to the way it was trained

VIC 2.0 will inform you when it time to speak by playing an audible "beep".

INCORRECT

VIC 2.0

4-1

VIC 2.0 INSTALL MANUAL