Audioplex AT-6P Instrukcja instalacji - Strona 2
Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Sprzęt nagrywający Audioplex AT-6P. Audioplex AT-6P 3 stron. Six speaker selector with automatic impedance matching protection
Drukuj stronęConnect each of the two amplifiers to the "A" and "B" terminals as shown. Make sure the + and -, and
L and R channel connections are correct to avoid unsatisfactory operation or dead channels.
The same precautions should be used when connecting the speakers, crossed channels, polarity , or
grounds will result in improper operation.
Rubber feet provide a non-marring, stable mount for the AT-6P switcher. They are high enough to help
promote air circulation under the unit, keeping it cool. A good precaution is to install in a manner that
allows free air circulation around the unit. Avoid placing the AT-6P on any surface that is easily damaged
by heat, the switchbox can become quite warm if operating with all speakers "ON" at high power.
The AT-6P front panel buttons all operate in the same manner, push to turn ON, push again to turn OFF.
The switch is "ON" when pushed in closest to the AT-6P front panel.
To select speaker pairs, push the buttons in for the desired choices. If all speakers are 8 and/or 16
Ohms, proper loading for the amplifier is automatic no matter what combination is selected. If some of the
speaker pairs in each group of 3 (1, 2 & 3, or 4, 5 & 6) are rated at 4 Ohms, the associated 4 Ohm switch
should be pushed in when more than one pair of speakers is operating simultaneously in that bank. The
automatic impedance matching circuits will then provide proper protection at all times regardless of the
number of speaker systems in operation.
Your AUDIOPLEX TECHNOLOGY AT-6P Speaker Selector Switch is covered by a LIFETIME
warranty against any defects in workmanship and materials. Any defects will be remedied without charge
for labor or parts.
Damage incurred by shipping or accident is not considered to be a defect, and not covered by this
warranty. AUDIOPLEX TECHNOLOGY, is not responsible for defective operation caused by abuse or
by modification or service by any unauthorized person or agency.
The unit must be properly installed and operated according to instructions for the warranty to apply .
Any necessary servicing must be done by AUDIOPLEX TECHNOLOGY. The product must be returned
expenses prepaid, with written authorization from the company. The product must be shipped with the
proof of purchase and in the original carton and packing material to avoid damage.
This warranty gives you specific legal rights. You may have other rights which vary from state to state.
OPERATION
:
WARRANTY: