AudioPressBox APB-216 C Instrukcja obsługi - Strona 5

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Wzmacniacz AudioPressBox APB-216 C. AudioPressBox APB-216 C 9 stron. Press conference audio distribution amplifier

AudioPressBox APB-216 C Instrukcja obsługi
APB-216 C
1) Input XLR microphone/line connector
Input your microphone or line-level source into this
XLR balanced connector. You can connect any type of
condenser either dynamic microphone here.
(1:Ground; 2:Hot, 3:Cold).
2) Phantom power indicator
If you are about to use condenser microphone, turn
Phantom power switch ON to feed your microphone with
24/48V. If you use dynamic microphone or microphone
with his own power, you can switch this OFF.
3
5
4
2
1
10
Be sure to leave this switch off (
need phantom power.
CAUTION
When tuning the switch on (
mics are connected to the XLR input. Devices other than
condenser mics may be damaged if connected to the phantom
power supply. Note, however, that the switch may be left on
when connecting to balanced dynamic microphones.
To avoid damage to speakers, be sure to turn off ampli ers (or
powered speakers) before turning this switch on or off. We also
recommend that you turn all output controls to their minimum
settings before operating the switch to avoid the risk of loud
noises that could cause hearing loss or device damage.
9
) if yo u do not
), be sure that only condenser
5
8
3) Mic/Line Input switch
If you are using microphone as an input, this lever should
be set to "Mic" position. If you are using Line input or
input from the mixing console, please set this switch to
"Line" position. You can check the output level on the
Output level meter (5).
4) Input gain level knob
You can set the input signal level depending on the
connected audio source to reach the optimal output level.
6
7