AudioPressBox APB-216 C Посібник користувача - Сторінка 5

Переглянути онлайн або завантажити pdf Посібник користувача для Підсилювач AudioPressBox APB-216 C. AudioPressBox APB-216 C 9 сторінок. Press conference audio distribution amplifier

Друкувати сторінку

APB-216 C

1) Input XLR microphone/line connector

Input your microphone or line-level source into this

XLR balanced connector. You can connect any type of

condenser either dynamic microphone here.

(1:Ground; 2:Hot, 3:Cold).

2) Phantom power indicator

If you are about to use condenser microphone, turn

Phantom power switch ON to feed your microphone with

24/48V. If you use dynamic microphone or microphone

with his own power, you can switch this OFF.

Be sure to leave this switch off (

need phantom power.

CAUTION

When tuning the switch on (

mics are connected to the XLR input. Devices other than

condenser mics may be damaged if connected to the phantom

power supply. Note, however, that the switch may be left on

when connecting to balanced dynamic microphones.

To avoid damage to speakers, be sure to turn off ampli ers (or

powered speakers) before turning this switch on or off. We also

recommend that you turn all output controls to their minimum

settings before operating the switch to avoid the risk of loud

noises that could cause hearing loss or device damage.

) if yo u do not

), be sure that only condenser

3) Mic/Line Input switch

If you are using microphone as an input, this lever should

be set to "Mic" position. If you are using Line input or

input from the mixing console, please set this switch to

"Line" position. You can check the output level on the

Output level meter (5).

4) Input gain level knob

You can set the input signal level depending on the

connected audio source to reach the optimal output level.