Audiovalve BALDUR 300 Instrukcja - Strona 10
Przeglądaj online lub pobierz pdf Instrukcja dla Wzmacniacz Audiovalve BALDUR 300. Audiovalve BALDUR 300 17 stron. High power, high current class -a triode amplifier
Drukuj stronęINSTALLATION AND OPERATION
MAINS VOLTAGE
CHECK that the mains voltage printed on the rear of this
amplifier is similar to the mains voltage normaly supplied to
your area. If indoupt, please consult your AUDIOVALVE dealer.
PLACEMENT AND VENTILATION
This AudioValve Baldur 300 power amplifier is designed to
operate at a moderately high temperature. The ideal location
is on the rigid stand or floor mounted away from direct contact with any
objects, materials or deep pile carpets which may be effected by the heat
or which may interrupt the flow of air around the amplifier.
When operating the amplifiers quite a lot of heat is generated which
should be allowed to dissipate without restriction. Make sure that no
objects are placed on the top of the amplifier. Always ensure adequate
ventilations.
MAINS / LINE POWER connection is via supplied plug-in lead. The
standard IEC socket connects the mains power at the amplifier end while a
local mains plug is required at the wall end. In the event where a "local"
plug needs to be fitted to the wall end of the lead, ensure the at the plugs
is wired correctly by a suitable qualified or experienced person.
Ensure the main switch of the front of this amplifier is OFF before
attempting any modification of the mains connection.
MAINS / LINE FUSE
A Mains / Line fuse is fitted within the IEC Mains / Line socket on the
rear of the amplifier. A small draw at the bottom of this socket may be
removed (after the IEC plug is removed) by levering it out with a flat
blade screw driver. The fuse fitted should be razed at no greater than 10
ampere slow blow.
In the unusual event that this fuse should blow, you must first
establish the cause of this failure, cure the fault and then replace the
fuse with one of the same type.