Audiovalve BALDUR 300 Инструкция - Страница 10

Просмотреть онлайн или скачать pdf Инструкция для Усилитель Audiovalve BALDUR 300. Audiovalve BALDUR 300 17 страниц. High power, high current class -a triode amplifier

Печатать страницу

INSTALLATION AND OPERATION

MAINS VOLTAGE

CHECK that the mains voltage printed on the rear of this

amplifier is similar to the mains voltage normaly supplied to

your area. If indoupt, please consult your AUDIOVALVE dealer.

PLACEMENT AND VENTILATION

This AudioValve Baldur 300 power amplifier is designed to

operate at a moderately high temperature. The ideal location

is on the rigid stand or floor mounted away from direct contact with any

objects, materials or deep pile carpets which may be effected by the heat

or which may interrupt the flow of air around the amplifier.

When operating the amplifiers quite a lot of heat is generated which

should be allowed to dissipate without restriction. Make sure that no

objects are placed on the top of the amplifier. Always ensure adequate

ventilations.

MAINS / LINE POWER connection is via supplied plug-in lead. The

standard IEC socket connects the mains power at the amplifier end while a

local mains plug is required at the wall end. In the event where a "local"

plug needs to be fitted to the wall end of the lead, ensure the at the plugs

is wired correctly by a suitable qualified or experienced person.

Ensure the main switch of the front of this amplifier is OFF before

attempting any modification of the mains connection.

MAINS / LINE FUSE

A Mains / Line fuse is fitted within the IEC Mains / Line socket on the

rear of the amplifier. A small draw at the bottom of this socket may be

removed (after the IEC plug is removed) by levering it out with a flat

blade screw driver. The fuse fitted should be razed at no greater than 10

ampere slow blow.

In the unusual event that this fuse should blow, you must first

establish the cause of this failure, cure the fault and then replace the

fuse with one of the same type.