Duratuf SENTRY SS2007 Instrukcja montażu - Strona 8
Przeglądaj online lub pobierz pdf Instrukcja montażu dla Przechowywanie na zewnątrz Duratuf SENTRY SS2007. Duratuf SENTRY SS2007 16 stron.
Drukuj stronęASSEMBLE DOOR
SELECT:
2 x 1.810m Door Sheets
2 x 1.810m Door Sheets 1 pan
4 x 0.715m Door Top/Bottom Flashings
4 x 1.810m Door Side Flashings
1 x 1.810m Weather-strip
6 x Hinges
1 x Padbolt Support Flashing
4 x 1.100m Door Brace Flashings
106 x Rivets
STEP 1:
•
Lay out 1 x 1.810m Door Sheet and 1 x
1 Pan Sheet on a flat surface.
•
Rivet sheets together in the centre
ensuring ends are flush with each other.
STEP 2:
•
Position door side flashings and top and
bottom flashings and assemble door as
shown, ensuring narrow face of flashing
is on the front as per fig.1
•
Drill and rivet as per diagram.
STEP 3:
• Attach hinges to door side flashing using rivets provided.
Ensure hinge is flush with back of door, and 60mm in from
each end as per fig.2.
• Using six rivets, attach padbolt support as shown in fig. 3
STEP 4:
• On the back of the door, place door braces in position
as shown in fig.4
• Ensure that the top and bottom ends of the braces
are under the door flashings as shown in fig.5 and
opposite ends of the braces overlap in the middle as
shown in fig.6.
• Rivet door brace flashings onto back of door as
shown. Where possible, rivet from front of door.
STEP 5:
• Assemble second door as above but attach weather
strip flashing to back of door side flashing using six
rivets ensuring it protrudes 20mm out from door side.
fig.1
Hinges
fig.5
8
fig.3
fig.2
fig.4
fig.6