475 e2 Instrukcja instalacji - Strona 4

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Wentylator 475 e2. 475 e2 7 stron. With 5/uni-fr

ASSEMBLY – INSTALLATION PIPES (continued)

Apply exterior finishes and waterproofing with

ROFLEX/TESCON tape combination or other

construction type specific measures.

ASSEMBLY - ELECTRIC INSTALLATION AND ELECTRIC CONNECTION

Safety Instructions: Beware! Any assembly work to the ventilation device may only be carried

out when all of the supply current has been disconnected! Make sure that all electrical circuits are

turned off. All controllers of this ventilation system should be installed on a AFCI protected circuit.

⚠

Electric connection only by a licensed electrician.

Questions? Email: [email protected] | Call: 800-995-6329

Remove the construction protection lid outdoors. Insert

and attach the exterior grill using the integrated claw

fasteners (tighten screws). Make sure the exterior grill

mounted with the louvers directing rain away from the

tube. Exterior grill finishes are also available in:

stainless steel, grey, burgundy, and white.

●

The system is controlled by

Universal Control 5/UNI-FR.

●

Select the location for the switch.

●

Run the wiring (120V + 12V cables

to the device pairs).

●

120V cable (14 gauge).

●

12V to each fan (3 x 18 gauge solid

thermostat wire).

●

Controller is wired and set per

diagram on following page.