Aplisens CS-27/BAK Instrukcja obsługi - Strona 8

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Przyrządy pomiarowe Aplisens CS-27/BAK. Aplisens CS-27/BAK 13 stron. Hydrostatic fuel level probe for installation on the fuel filler

Drukuj stronę
IO.CS-27/W.CS-27/BAK
 Unscrew the original filler cap.
 Degrease the filler surface and probe body (1) with a cloth included in installation kit.
 Apply silicone to filler surface and body (1).
 Mount seal (2) on body (1).
 Mount body (1) with seal (2) on filler. It is recommended to install the flange in such a
way, so that the wire does not protrude outside the vehicle.
 Carefully drill Ø 4 mm openings in filler through mounting openings.
 Place installation sleeve (3) onto blind rivet (4) and embed in riveter. Rivet both openings.
 Secure the wire with protective pipe, clamp the pipe at wire outlet with cable tie, lead the
wire into driver's cabin in such a way as to minimize possible thermal and mechanical
damage resulting from regular usage of vehicle.
 Thread the sealing cord with bead through sealing openings so that it does not screen
the rivet head, wrap the cord around the protective pipe and seal it.
 Insert silicone into mounting openings and push in rubber plugs.
 Cut off the protruding part of plug.
 Screw the cap on. Unscrew and screw the cap back on several times to verify the
stability of mounting on the tank filler.
7.2
CS-27/BAK/60; CS-27/W/60 mechanical installation
 Unscrew the original filler cap.
 Degrease the filler surface and lower body (1) with a cloth included in installation kit.
 Apply silicone to filler surface and lower body (1).
 Mount seal I (3) on body (1).
 Mount body (1) with seal I (3) on filler. It is recommended to install the body in such a
way, so that the wire does not protrude outside the vehicle.
6
02.B.003