Dascom DP-520 Podręcznik użytkownika - Strona 8

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Drukarka Dascom DP-520. Dascom DP-520 12 stron. Wired printer
Również dla Dascom DP-520: Instrukcja obsługi (19 strony), Instrukcje szybkiej konfiguracji (2 strony), Instrukcje szybkiej konfiguracji (2 strony)

The DT-520 has an industry standard RS-232 interface. The default parameters are 9600 baud, 8 data

bits, 1 stop bit and no parity. Other baud rates can be programmed by control codes, or by using a setup

utility. Contact Dascom Technical Support for information regarding the setup utility.

Serial data is expected in standard RS-232C format with -12V meaning 'mark' or '1' and +12V a logical '0',

with reference to the common ground. The serial data output line, TxD, transmits XON/XOFF and status

information to the host at the same Baud rate and in the same format as the serial data input. The

hardware busy line is true (nominal -12V) when busy. Both serial output lines will relax to approximately

0V when the printer is in sleep mode, and the user must allow a short period after awakening before

relying on the values of these signals.

Some host equipment use a constant space condition (+12V) to indicate a reset condition or wait state.

Some battery powered host equipment present the same output signal when they go to sleep. The printer

can be set to ignore this condition as detailed in the Programmer's Manual, but even then this type of host

behavior may result in one or more spurious characters being received and printed.

The printer has two user connectors shown below:

Charger Input

Charger Input Socket Detail

Dimension (mm)

Inner

Inside

Ø 2.5

Outer

Outside Ø 5.5

The maximum insertion length is 12 mm.

INTERFACE DETAILS

Function

Positive / Charger Input

Negative / 0V Common

Pin 1

RJ12 Combined Data Socket