Cayken SCY-2550 Instrukcja obsługi - Strona 7

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Wiertarka Cayken SCY-2550. Cayken SCY-2550 19 stron.

15. When working in the open,use only authorized extension cable which are identified

for such use.

16. Always be alert,Observe your work.Proceed with care and do not use the power tool

if you can't concentrate.

17. Check your machine regularly.Before using the power tool again,you must check

carefully that protective devices or damaged parts are functioning correctly,that they

are not sticking,that no parts are broken,that all other parts are correctly and perfectly

fitted and that all other conditions which could influence the operation of the machine

are safe and correct.Damaged protective devices and parts should be repaired or cha-

nged at a customer service work shop,unless otherwise indicated in the operating in-

structions.Damaged switches must be replaced at a customer service workshop.Do

not use power tool if the switch can't be switched on or off.

18. Attention:For your good,please only use the accessories and additional equipment

fromoriginal supplier.The use of other accessories may cause damage to the tod and

the operator

PREPARATION

Please follow the steps below,assemble and connect the core drill machine.You

can do this works with tools attached with the machine.

ATTENTION:You must make sure that the motor's switch is off when connecting

up the power supply.

Step 1:Unwrap the package,check the machine and accessories according tothe

packing list.Satisfy yourself that the machine has not been damaged in transit.

Check that the voltage is the same as the voltage indicated on the rating plate.

Check all the parts according to the packing list.

Step 2:Electrical connection

According the European standard EN 61029-1 and IEC 1029-2-6,the electrical connection

of diamond core drills with water supply must be operated via a residual current device and

to a properly earthed socket.In accordance with these regulations,our products is fitted w-

ith an PRCD.This contains both RCD protection and under voltage tripping.The PRCD must

be switched on using the ON key after the power plug has been inserted into the socket .In

the event of a voltage drop,the PRCD will switch off and must then be switched on again

once the power supply has been reestablished.The rated current,i.e. The rated current for

the PRCD switch off,is 30 mA.

ATTENTION:the PRCD must not lie in water.It must be checked for

perfect function at regular inter vals by pressing the TEST key.