Cayken SCY-2550 Instrukcja obsługi - Strona 8

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Wiertarka Cayken SCY-2550. Cayken SCY-2550 19 stron.

Never operate a diamond core drilling machine without PRCD .

STEP 3 water connection.

Use the attached accessries "Quick connector"to connect the water hose to the water supply

system.

ATTENTION:Use only clean water,as dirty water will cause the seals wear very

quickly.Max. Water pressure 3 bar.

Step 4 Safety test

After having switch on the motor starts softly.Press "TEST" button on the PRCD,the motor

stop immediately.Press RESET button on the PRCD to supply electricity again.

ATTENTION:Do not operate the machine if the PRCD goes wrong.

PUTTING INTO OPERATION

1.Select suitable diamond drill bits.

Our products have 4 kinds of thread,only use suitable high quality diamondtools,

use sharp tools and ensure that the diamond segments are sufficiently larger than

the inner and outer diameter of the drill bit tube.Apply water-resistant grease to the

tool thread so that the tool can be easily loosened.Ensure that the radial run out at

the diamond segments of the drill bit is no greater than 1mm(eccentricity.)

2.Fix the rigs to the working place

Fixing methods:bolt fixing,vacuum fixing,bracing.The most common met-hod of

fixing is dowel fixing.Use metal bolt if possible.The diameterof the bolt must be at

least 12mm.With vacuum fixing,ensure there is a sufficiently great suction.Make

sure that the sealing ring are not worn out.Ensure that the rig is only rigid when the

sealing ring is relaxed via jack screws on the base of the rig.

Note: We strongly recommend the use of the expansion bolt is fixed, and as the

location of the expan-sion screwThe column is the best direction. the company

doesnot assume any responsibility for result from unfirn fixation.

3.start drilling

Fix the drill bit, connect the power and water supply, move adjusting tools, switch

on when the drill machine is no load, check the drill bit and sound, if ever ything is

fine, then open the water tap, the machine can start to drill when water flow from

the drill bit.

Take it slow when at first, when the drill bit cut in the wall, change to normal spe-

ed. Slow down when the drill machine run into steel.

Both mechanical and electronic protections exist in drill machine. When drilling,

if the motor is working, while the drill bit is not moving, means the drill bit need