Datapath activesqx Podręcznik użytkownika - Strona 6

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Karta PCI Datapath activesqx. Datapath activesqx 15 stron.

Installing ActiveSQX Cards

You are likely to need a flat blade and/or a cross head screwdriver for the installation of the ActiveSQX

card; it would be useful to have these to hand before you begin.

•

Power down the PC (including peripherals), switch off at the mains and disconnect all the cables

connected to the computer, noting the positions for accurate re-connection

•

Remove the PC cover

•

Locate a vacant PCI Express slot (x4 or higher) on the motherboard and remove the blanking plate

(retain all screws)

If you are in doubt consult your motherboard documentation to correctly identify a PCI Express slot.

If the card is forced into a 32 or 64 bit PCI or PCI-X slot it will be irreparably damaged when the system

is powered up and the warranty will be void.

•

Reconnect all cables to the PC then connect Network cables (not supplied) to the Ethernet port on the

ActiveSQX capture card

•

Power up the PC and commence the software installation

Multiple ActiveSQX cards can be installed into a system providing more processing and more

simultaneous decodes.

Note:

The ActiveSQX card is only compatible with systems containing Datapath ImageDP4

graphics cards.

How to Connect Input Sources

The ActiveSQX card has two Ethernet ports and one currently dormant output DisplayPort connector

(reserved for future use).

Ethernet Port LED's

Green = Activity

Yellow = Link Speed

(On = 100bT)

(Off = 1000bT)

Connect a network cable into one or both of the Ethernet ports. Care should be taken when connecting a

network cable, ensure the cable connector is pushed firmly into the Ethernet port until you hear a definite

click. Failure to connect the network cable properly could result in the network connection being lost.

LAN1

LAN2

Output DisplayPort

(Reserved for future use)