4ms Company SCMBO Podręcznik konstruktora - Strona 2

Przeglądaj online lub pobierz pdf Podręcznik konstruktora dla Sprzęt komputerowy 4ms Company SCMBO. 4ms Company SCMBO 4 stron. Shuffling clock multiplier breakout (expansion module for the shuffling clock multiplier) kit builder's guide for pcb v1.1

Step 2: Resistor Arrays
Insert and solder the 5 resistor arrays. Each array has a white dot on one end, which must go into the
hole that's boxed out on the PCB (towards the left, as shown in the photo).
• 10k isolated array, 8-pins x 3 (labeled 8B103G)
• 470k bussed array, 10-pins x 1 (labeled 10A474G)
• 330ohm bussed array, 10-pins x 1 (labeled 10A331G)
Step 3: Capacitors, header pins, trim-pot
Insert and solder the six green capacitors, the 16-pin header, and the trim-pot. The caps and header pins
may be orientated either way, and the trim-pot will only fit one way.
1000pF "102" capacitors x 6
10k trim-pot x 1
16-pin header x 1
Step 4: Pots and Switches
Insert the 5 pots and 2 switches, but DO NOT SOLDER YET.
There are two types of pots: the Linear taper has a detent in the center that you can feel when you turn
the shaft. The Audio taper has no detent.
Slip, Shuffle, PW: 10k Linear taper with center detent ("10 3B")
Rotate, Skip: 10k Audio taper without detent ("10 3A")
4x Fast, Mute: SPDT right-angle mount switches