Agri-Fab 45-0364 Instrukcja obsługi - Strona 5
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Rozrzutnik Agri-Fab 45-0364. Agri-Fab 45-0364 12 stron. 250 lb. atv broadcast spreader owners manual
Drukuj stronę9. Assemble a spacer (P), a 3/4" flat washer (K), a wheel
(air valve facing out) and another 3/4" flat washer (K)
onto the end of the axle that has both the large and
small holes. See figure 4.
10. Install a 1/8" x 1-1/2" cotter pin (M) into the small hole
in the end of the axle. See figure 4.
11. Open the bail on the drive pin (V) and install it through
the wheel and the large hole in the axle. Close the bail
to lock the pin in place. See figure 4.
(V) DRIVE PIN
(M) 1/8" x 1-1/2"
COTTER PIN
AIR VALVE
(K) 3/4" DIA.
FLAT WASHER
FIGuRE 4
12. Turn the spreader upright on its wheels.
13. Assemble the flow control mounting tube to the hitch
tube using two 5/16" x 1-3/4" hex bolts (A) and 5/16"
hex lock nuts(G). DO nOT TIGHTEn YET. See figure
5.
14. Assemble the vinyl cap (S) onto the flow control mounting
tube. See figure 5.
(S) VINYL CAP
(A) 5/16" x 1-3/4"
HEX BOLT
FIGuRE 5
(P) SPACER
(G) 5/16"HEX
LOCK NUT
15. Assemble the flow control mounting bracket and the tube
support strap to the flow control mounting tube using
two 5/16" x 1-3/4" hex bolts (A), four 5/16" washers (J)
and two 5/16" hex lock nuts (G). DO nOT TIGHTEn
YET. See figure 6.
16. Remove the preassembled bolt and nut from the front of
the hopper. Attach the tube support strap to the hopper
and hopper strap using the bolt and nut you removed.
TIGHTEn the nut and bolt. See figure 6.
TUBE
SUPPORT
STRAP
(G) 5/16" HEX
LOCK NUT
FIGuRE 6
17. TIGHTEn the two bolts which fasten the flow control
mounting tube to the hitch tube. DO nOT TIGHTEn the
two bolts which fasten the flow control mounting bracket
to the flow control mounting tube.
5
PREASSEMBLED
BOLT AND NUT
HOPPER
STRAP
(J) 5/16"
FLAT WASHER
(A) 5/16" x 1-3/4"
HEX BOLT