Agri-Fab 45-0364 Instrukcja obsługi - Strona 7

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Rozrzutnik Agri-Fab 45-0364. Agri-Fab 45-0364 12 stron. 250 lb. atv broadcast spreader owners manual

Drukuj stronę

(Q) NYLON

WING NUT

(J) 5/16" FLAT

WASHER

(I) NYLON

WASHER

(R) ADJUSTABLE

STOP

(E) 1/4" x 3/4"

CARRIAGE BOLT

FIGuRE 11

24. Position the flow control mounting bracket (figure 12).

a. Push on flow control arm until it locks in "OFF"

position.

b. Slide flow control mounting bracket along tube until

closure plate in bottom of hopper just closes.

c. Snug the 5/16" lock nuts just enough to hold flow

control mounting bracket in place.

d. Set adjustable stop at "5". Pull flow control arm

against stop. Verify that closure plate has opened

about half way.

e. If closure plate does not open half way, adjust

position of flow control mounting bracket until

closure plate will open about half way at "5" and

will still close when arm is locked in "OFF" position.

Tighten the 5/16" lock nuts.

FLOW

CONTROL

ARM

ADJUSTABLE

STOP (S)

(SETTING "5")

FIGuRE 12

25. Assemble the hitch bracket to the hitch extension bracket

using two 3/8" x 3/4" hex bolts (C) and 3/8" hex lock nuts

(H). Insert the bolts from the bottom. See figure 13.

26. Assemble the hitch pin (O) through the hitch bracket

and the hitch extension bracket and secure with the

hair cotter pin (N). See figure 13.

FIGuRE 13

27. For most vehicles, assemble the hitch extension bracket

to the holes in the hitch tube shown at the top of figure

14. Use two 1/4" x 1-3/4" hex bolts (B) and 1/4" hex lock

nuts (F) tightened only finger tight. Attach the spreader

hitch to your vehicle hitch. Check for interference with

the spreader directly behind and out to both sides of

the vehicle. Lift the spreader at each position to make

sure there is no interference with the spreader's flow

control. If there is interference with the rear of the vehicle,

assemble the hitch extension bracket as shown at the

bottom of figure

14. Tighten the bolts and nuts when finished.

(F) 1/4" HEX

LOCK NUT

FIGuRE 14

(O) HITCH PIN

(H) 3/8" HEX

LOCK NUT

HEX BOLT

(N) 1/8" HAIR

COTTER PIN

(B) 1/4" x 1-3/4"

HEX BOLT