4qd JSK-120 Instrukcja obsługi - Strona 2

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Kontroler 4qd JSK-120. 4qd JSK-120 4 stron.

Mounting

The JSK-120 requires a 47mm diameter hole in the mounting panel. There is no

limitation on the panel thickness.

Connections

The JSK-120 uses the Vishay 981HE sensor and the wiring colours are somewhat

counter intuitive....



Green = +5V



Red = Signal



Yellow = Ground [0V]

These should be connected to the Pro-160 / 360 control board as follows.

Calibration

The Pro-160 / 360 should have the throttle setting / input mode set to "volt".

If the center detent is being kept, joystick mode should be set to "on".

The pot learn procedure should then be carried out as described in the

controller manual.

JSK-120 V1.0 05/21

Page 2