Dateq XTC II Podręcznik - Strona 12

Przeglądaj online lub pobierz pdf Podręcznik dla Sprzęt dla DJ-ów Dateq XTC II. Dateq XTC II 19 stron.

Setup

Jumper settings

To be able to reach the internal jumpers the AC-cord has to be disconnected

from the mains first. Then the 8 torx screws of the front panel can be

unscrewed and the front panel can be flipped open gently .

MIC Phantom voltage

Inside left, at the back, on the top board the Mic-Phantom jumper

is situated. This controls the phantom voltage:

ON is top position,

OFF is the bottom position.

Phono / Line select

Inside, at the back, on the bottom

board the Phono/line jumpers are

situated. These control the input

sensitivity of channel 2,3 and 4:

LINE

is the top position,

PHONO is the bottom position.

DJ Cleanfeed

On the VCA-board mounted at the

back of the Main-board (front) the

Cleanfeed DJ jumpers are

situated. These jumpers control

the DJ signal to be filtered out of

the monitor ON, or not OFF:

CF-OFF is the right position(2x),

CF-ON is the left position (2x).

Limiter lock

At the back of the Main-board (front) under the VU-meter the limiter-lock option named "Lock" is

situated. The 2 pins "ON" control this option:

ON is linked,

OFF is open.

The front panel can now be closed gently and the 8 torx screws fastened.

Then the AC-cord can be connected to the mains.

Chan.2

Chan.3

Cleanfeed DJ

DATEQ XTC II manual

Chan.4

Phono/Line

Phantom