4qd BCM-L100 Instrukcja obsługi - Strona 3

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Przyrządy pomiarowe 4qd BCM-L100. 4qd BCM-L100 4 stron. Battery capacity meter

3.3 Upper / lower percentage values

In sub-section 3, the left 3 digits show the voltage corresponding to 0% capacity,

the right 3 digits show the voltage corresponding to 100% capacity.

Move between the digits with

, when a digit is flashing, increase the value with >,

press and hold

to save and return to the setup menu.

3.4 Alarm function

In sub-section 4 the left side shows if the alarm function is on or off, the right side

shows the voltage below which the warning symbol will flash.

Move between the sections and digits with

, when a digit is flashing, change the

value with >, press and hold

to save and return to the setup menu. Press and

hold > to exit the setup menu if required.

3.5 Calibration.

Connect the meter to an accurate 20V source, enter sub-section 5, press and hold

to calibrate the meter. Press and hold > to exit the setup menu.

4. Dimensions

Length = 61.5mm, width = 33.5mm, height = 13.5mm.

5. Mounting

The BCM-L100 can be clipped into a rectangular slot 58mm x 28mm.

6. Water Resistance

The BCMs are not water proof, the front of the panel is a sealed membrane, but

there are gaps at the rear that should be sealed if water resistance is required.

7. Service

The BCMs are a low cost item and cannot be economically repaired. If the item is

not under warranty it should be replaced.

BCM-L100 V1.0 05/19

Page 3