AUSTRALIAN MADE GREAT MATE Instrukcje instalacji i konfiguracji - Strona 11

Przeglądaj online lub pobierz pdf Instrukcje instalacji i konfiguracji dla Silnik AUSTRALIAN MADE GREAT MATE. AUSTRALIAN MADE GREAT MATE 20 stron. Double swing gate motor kit

Drukuj stronę

Attaching the Arms and Brackets to the Gate

FOR OUTWARD OPENING GATES REFER TO THE SPECIAL INSTRUCTION SHEET

Refer to the "Internal Manual Release" instructions on page 5. Disengage the motor gear by

loosening the internal release bolt and push the DC motor away from the gearing. The motor

drive arm should now be free to rotate by hand.

Move the gate into the closed position manually.

Fit the swing arm assembly to the drive arm. Loosely attach the standard gate bracket to the

other end of the swing arm assembly.

Extend the swing arm straight out and mark a position where the standard gate bracket touches

the gate.

Measure approximately 40mm back towards the gate motor from the marked position and attach

the standard gate bracket to the gate at this point.

Tighten the two swing arm bolts with care not to over tighten. Open and close the gate manually

by hand several times to test.

Swing Arm Assembly

Screw the two 12mm bolts with lock washers (not

shown) to attach Swing Arm Assembly to the

Drive Arm.

Standard Gate

Mounting Bracket

DOUBLE GATE MOTOR

INSTALLATION AND SET UP

INSTRUCTIONS

Drive Arm

Swing Arm end

Swing Arm Bolt

Standard

Gate Bracket

with Brass

Olive, Bolt

and Nut

Swing Arm Bolt