Bend-Pak HD-12LS Instrukcja instalacji i obsługi - Strona 3
Przeglądaj online lub pobierz pdf Instrukcja instalacji i obsługi dla Systemy podnoszenia Bend-Pak HD-12LS. Bend-Pak HD-12LS 20 stron. 12,000 pound capacity four-post lift
Drukuj stronę
1. Carefully remove the crating and packing
materials. CAUTION! Be careful when cutting
steel banding material as items may become
loose and fall causing personal harm or injury.
2. Inspect the lift for any signs of concealed
shipment damage or shortages. Remember to
1. READ AND UNDERSTAND all safety warning
procedures before operating lift.
2. KEEP HANDS AND FEET CLEAR. Remove hands
and feet from any moving parts. Keep feet clear of lift
when lowering. Avoid pinch points.
3. KEEP WORK AREA CLEAN. Cluttered work areas
invite injuries.
4. Consider work area environment. Do not expose
equipment to rain . DO NOT use in damp or wet
locations. Keep area well lighted.
5. ONLY TRAINED OPERATORS should operate this
lift. All non-trained personnel should be kept away from
work area. Never let non-trained personnel come in
contact with, or operate lift.
6. USE LIFT CORRECTLY. Use lift in the proper
manner. Never use lifting adapters other than what is
approved by the manufacturer.
7. DO NOT override self-closing lift controls.
8. REMAIN CLEAR of lift when raising or lowering
vehicle.
9. CLEAR AREA if vehicle is on danger of falling.
10. ALWAYS INSURE that the safeties are engaged
before any attempt is made to work on or near vehicle.
11. DRESS PROPERLY . Non-skid steel -toe footwear
is recommended when operating lift.
12. GUARD AGAINST ELECTRIC SHOCK. This lift
must be grounded while in use to protect the operator
THIS SYMBOL POINTS OUT IMPORTANT SAFETY INSTRUCTIONS WHICH IF NOT FOLLOWED
COULD ENDANGER THE PERSONAL SAFETY AND/OR PROPERTY OF YOURSELF AND OTHERS
AND CAN CAUSE PERSONAL INJURY OR DEATH. READ AND FOLLOW ALL INSTRUCTIONS IN
THIS MANUAL BEFORE ATTEMPTING TO OPERATE THIS MACHINE.
INTRODUCTION
IMPORTANT SAFETY INSTRUCTIONS
Read these safety instructions entirely!
report any shipping damage to the carrier and
make a notation on the delivery receipt.
3. Check the voltage,
amperage requirements for the motor shown on
the motor plate. Wiring should be performed by a
certified electrician only.
from electric shock. Never connect the green power
cord wire to a live terminal. This is for ground only.
13. DANGER! The power unit used on this lift contains
high voltage. Disconnect power at the receptacle before
performing any electrical repairs. Secure plug so that it
cannot be accidentally plugged in during service.
14. WARNING! RISK OF EXPLOSION. This
equipment has internal arcing or sparking parts which
should not be exposed to flammable vapors. This
machine should not be located in a recessed area or
below floor level.
15. MAINTAIN WITH CARE. Keep lift clean for better
and safe performance. Follow manual for proper
lubrication and maintenance instructions. Keep control
handles and/or buttons dry, clean and free from grease
and oil.
16. STAY ALERT. Watch what you are doing. Use
common sense. Be aware.
17. CHECK FOR DAMAGED PARTS. Check for
alignment of moving parts, breakage of parts or any
condition that may affect its operation. Do not use lift if
any component is broken or damaged.
18. NEVER remove safety related components from
the lift. Do not use lift if safety related components
are damaged or missing.
3
phase and proper