Bend-Pak HD-12LS Instrukcja instalacji i obsługi - Strona 4
Przeglądaj online lub pobierz pdf Instrukcja instalacji i obsługi dla Systemy podnoszenia Bend-Pak HD-12LS. Bend-Pak HD-12LS 20 stron. 12,000 pound capacity four-post lift
Drukuj stronę
"Rotary Hammer Drill Or Similar ( If Anchoring )
"3/4" Masonry Bit ( If Anchoring )
"Hammer
"4 Foot Level
"Open-End Wrench Set: 7/16" - 1-1/8"
"Socket And Ratchet Set: 7/16" - 1-1/8"
"Hex-Key / Allen Wrench Set
Do not attempt to install this lift if you have never been trained on basic automotive lift installation procedures. Never attempt
to lift components without proper lifting tools such as forklift or cranes. Stay clear of any moving parts that can fall and cause
injury. These instructions must be followed to insure proper installation and operation of your lift. Failure to comply with these
instructions can result in serious bodily harm and void product warranty. Manufacturer will assume no liability for loss or
damage of any kind, expressed or implied resulting from improper installation or use of this product.
PLEASE READ ENTIRE MANUAL PRIOR TO INSTALLATION.
STEP 1
( Selecting Site )
Before installing your new lift, check the following.
1. LIFT LOCATION: Always use architects plans
when available. Check layout dimension against
floorplan requirements making sure that adequate
space is available.
2. OVERHEAD OBSTRUCTIONS: The area
where the lift will be located should be free of
overhead obstructions such as heaters, building
supports, electrical lines etc.
3. DEFECTIVE FLOOR: Visually inspect the site
where the lift is to be installed and check for
cracked or defective concrete.
STEP 2
( Floor Requirements )
This lift must be installed on a solid level
concrete floor with no more than 3-degrees
of slope. Failure to do so could cause
personal injury or death.
A level floor is suggested for proper installation
and level lifting. If a floor is of questionable slope,
consider a survey of the site and/or the possibility
of pouring a new level concrete slab.
TOOLS REQUIRED
"Medium Crescent Wrench
"Medium Pipe Wrench
"Crow Bar
"Chalk Line
"Medium Flat Screwdriver
"Tape Measure: 25 Foot Minimum
"Needle Nose Pliers
IMPORTANT NOTICE
"DO NOT install this lift on any asphalt surface
or any surface other than concrete.
"DO NOT install this lift on expansion seams or
on cracked or defective concrete.
"DO NOT install this lift on a second / elevated
floor without first consulting building architect.
"DO NOT install this lift outdoors unless special
consideration has been made to protect the
power unit from inclimate weather conditions.
HD-12LS
HD-12LSX
HD-12LSXE
All models MUST be installed on 2500 PSI concrete
only conformIng to the minimum requirements
shown above. New concrete must be adequately
4
CONCRETE SPECIFICATIONS
LIFT
MODEL
NOTE
cured by at least 28 days minimum.
CONCRETE
REQUIREMENT
4" Min. Thickness
4" Min. Thickness
4" Min. Thickness