Bender ATICS DIO Series Skrócona instrukcja obsługi - Strona 7

Przeglądaj online lub pobierz pdf Skrócona instrukcja obsługi dla Przełącznik Bender ATICS DIO Series. Bender ATICS DIO Series 13 stron. Automatic transfer switching devices for safety power supplies

Drukuj stronę

Quick start "Commissioning and operation"

ATICS-...-DIO Quick start

Automatic transfer switching devices for safety power supplies

Software version: D333 V1.2x/D334 V1.2x/D335 V1.0x

This reference guide does not replace the operating manual. You will find the operating manual in the download area of our homepage. Make sure

that the personnel has read this manual and understood all instructions relating to safety.

1. Safety instructions

Caution: Missing or false messages on the MK..., TM... or

FTC... because of out-dated software.

►

Replace or update older operating software of MK..., TM...,

FTC... or COM460

►

Update TMK-SET configuration software.

The attached checklist includes both the factory defaults and installation-specific settings for the ATICS® transfer switching device. Please carry

out all the work outlined in the list and log each test step.

Keep the checklist with this manual in the vicinity of the device.

2. Enabling manual mode

3. Configure MK... resp. TM...

MK... resp. TM... must display at least the following faults detected

by the ATICS®:

• Failure Line 1, failure Line 2

• Device error, device failure ATICS®

• Failure of the other MK... or TM...

• Device error with complete text or error code

4. Minimum parameter settings

The following minimum default settings have to be carried out:

• BMS bus address (see "Settings menu 8: Interface" in the oper-

ating manual)

• Delay times (see chapter "Setting and testing according to

checklist" in the operating manual)

By default, there is no password set on the ATICS®.

►

For operation of the device, it is absolutely essential to enter

and enable a password (see "Settings menu 10: password" in

the operating manual).

ATICS-DIO_D00080_02_Q_XXEN/04.2017

►

Open the transparent

cover of the automatic

transfer switching device.

The display shows "Man-

ual mode".

Note: Configure MK... resp. TM... in a meaningful way.

►

In addition to the message, configure a short remark of what

needs to be done and who is to be informed.

5. Operator control and display elements

ALARM COM

Pos.

LED/Button

Meaning

LC graphical dis-

play

LED "1"

lights up when Line 1 is ready

LED "2"

lights up when Line 2 is ready

LED "ALARM"

lights up when there is an alarm

message

LED "COM"

flashes during communication via the

BMS bus

"INFO" button

to query standard information,

"ESC" button

to leave the menu function without

changing parameters

"TEST" button,

Calls up test menu

Up button

Parameter changes, scrolling

"RESET" button

Resets alarm and fault messages,

unlocks switching back interlocking

function

Down button

Parameter changes, scrolling

"MENU" button

Toggles between the standard display,

alarm display and the "MENU"

Enter button

Confirms parameter changes