dymax BlueWave 50 Instrukcja obsługi - Strona 12

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Sprzęt oświetleniowy dymax BlueWave 50. dymax BlueWave 50 20 stron. Uv light-curing spot lamp system

Drukuj stronę

1. Specifications

OPERATION

The BlueWave

50 will arrive almost fully assembled. Please

refer to the Installation and System Interconnect section of this

manual for instructions on installing the Lightguide (sold

separately), Power Cord, and Footswitch.

The system should be positioned in a dry location that does not

obstruct airflow from the rear of the unit. To energize the system,

turn the Power Switch from the "O" position to the "l" position

(Figure 10). In the "I" position, the Fans, Hour Meter, Timer, and

50W Bulb should begin to function. This can be confirmed by

viewing the illuminated Bulb Status Indicator Light above the

Lightguide Mount (Figure 11). Before operating unit, allow the

50W Bulb to warm-up for approximately 5 minutes.

CAUTION:

Always wear protective goggles or face shield when

working near UV light. Never look directly at light exiting

Lightguide.

PRÉ-CAUTION:

Toujours porte lunettes de protection ou

protéger de visage en travaillant près lumière ultraviolette.

J'amais regarde directement à lumière sortie de le guide de

lumière.

The Timer located on the front panel of the BlueWave 50 is

factory set to the most common operating mode and

recommended operation of the Timer with the BlueWave. Some

modes available on the Timer may not operate correctly with the

BlueWave unit.

The front panel of the Timer contains a LCD Display and Keypad. The LCD Display has a Power Indicator, Signal

Input Indicator, Reset Indicator, Gate Input Indicator, Key Protect Indicator, Output Indicator, Preset Value, Set

Value, and Timing Operation Indicator. A brief description of each display and location:

• Power Indicator – Displays PW in upper left corner of Timer Display. Displayed when external power for

operation is present.

• Signal Input Indicator – Displays SIG in upper left corner of Timer Display, located to right of Power Indicator.

Displayed when activate signal is present.

• Output Indicator - Displays OUT in upper right corner of Timer Display. Displayed when Relay is switched to

NO; is not displayed when Relay is switched to NC.

• Present Value – Four digits segmented display in center of Timer. Shows current status of time.

• Set Value – Four digit segmented display in lower right corner of Timer. Shows set length of time.

• Timing Operation Indicator – Displays RUN in upper right corner to the left of Output Indicator. Displayed

when Timer is active.

To operate the Timer, select the "timed" option of the Switch on the front panel. Program the time into the Timer

and depress the Footswitch. Factory settings will open the Shutter and the present value will begin to count

backward. When the Timer reaches 00.00, it will reset the value to the set value and close the Shutter. The

Timer cannot be stopped once it's started. If the power is removed from unit, the Timer will reset to the set value.

To select the time, press the appropriate up key until the corresponding digit increments in the set value. By

pressing the up key labeled (1), it will increment the left most digit on the Set Display. By pressing the up key (2),

Figure 10. Power Switch

Figure 11. Bulb Status Indicator Light

BlueWave

50 Light-Curing Spot Lamp