Benedini TBS Micro V2.0 Podręcznik - Strona 7

Przeglądaj online lub pobierz pdf Podręcznik dla Sprzęt nagrywający Benedini TBS Micro V2.0. Benedini TBS Micro V2.0 9 stron.

2.4. Autostart

If you only want to play the engine sound, the "autostart" mode can be selected. The engine starts

automatically, as soon as the model is accelerated the first time.

If the engine is more than 20s idle, it shuts down automatically.

No special sounds can be played in this mode!

3. Power on transmitter and receiver. LED blinks fast -> normal mode

Bring throttle stick to idle. Motor must not move.

4. Bridge LRN contact for about 0.5 seconds until beep -> LED cont. on.

At this moment the idle position of the throttle stick is stored.

3. Move throttle stick to your desired acceleration point (throttle stick position where idle

dead band stops and engine running sound starts) and wait for a beep

Now the dead (neutral) band of the speed channel is defined.

4. Move the throttle stick to full speed position and wait for three beeps.

After this the sound unit is back in the normal operation mode.

During the programing sequence:

If you leave the last stored throttle stick position, a very short beep is played. Since then,

you have about 2 seconds to adjust the new throttle stick position to be stored next.

It is possible to change the adjusted control mode without the optional programing adaptor:

1. Bridge the LRN contact DURING powering the soundmodule

2. Remove the LRN contact

3. Close LRN contact momentary and wait for the "Beep-Code"

4. Repeat closing the LRN contact until the desired control mode is signalized by the

according "Beep-Code"

5. Switch soundmodule off and on again

„Beep-Code"

1 x Beep

2 x Beep

3 x Beep

Soundmodule TBS Micro V2.0

Autostart

Toggle switch

12 position encoder

Page:7