Benedini TBS Micro V2.0 Podręcznik - Strona 6

Przeglądaj online lub pobierz pdf Podręcznik dla Sprzęt nagrywający Benedini TBS Micro V2.0. Benedini TBS Micro V2.0 9 stron.

Benedini TBS Micro V2.0 Podręcznik
Indirect
2.3.
sound selection by a 3 position switch (toggle switch)
Another control mode is possible by using a toggle switch with neutral position (recommended),
or a common joystick at a available proportional channel.
A attached servo must leave its middle/neutral position when the switch is pressed in one
direction and must return to its middle position when the switch is released. Pushing the switch in
the opposite direction causes the servo to move to the other side.
Please compare the very left and right positions of the servo with a common joystick channel.
They should be about the same.
This is the first test you should do before programming the sound unit.
The control channel must be connected to

Selecting a Sound:

The desired sound (f.e. sound #3) is selected by pushing the switch/stick 3 times from its neutral
position to one direction. The selected sound is triggered/played by pushing the switch/stick to
the other direction. The last selected sound can be triggered multiple times, without new
selection.

Teaching the sound unit for toggle switch / joystick control

1. Power on transmitter and receiver. LED blinks fast -> normal mode
Bring throttle stick to minimum and control the center position of the toggle switch
2. Bridge LRN contact for about 0.5 seconds until beep -> LED cont. on.
At this moment all neutral positions are stored.
3. Move throttle stick to your desired acceleration point (throttle stick position where idle
dead band stops and engine running sound starts) and push the switch/joystick of the
control channel once
-> A short sequence of acceleration is played
Now the dead (neutral) band of the speed channel is defined
4. Move the throttle stick to full speed position and push the switch/stick of the control
channel again (like pos.3)
-> A short sequence of full speed is played.
After this the sound unit is back in the normal operation mode. All special sounds can be
controlled as mentioned above.
Soundmodule TBS Micro V2.0
Prop3
of the TBS Micro.
Page:6