GAC IGC700 Series Podręcznik - Strona 13

Przeglądaj online lub pobierz pdf Podręcznik dla Kontroler GAC IGC700 Series. GAC IGC700 Series 18 stron. Integral governor control

Drukuj stronę

Is RUN/SETUP

LED Blinking

With Power

applied to

IGC,

Is Fault LED

on?

Is RUN/SETUP LED

Blinking

Are any LED's on

Is RUN/ SETUP

LED steady On

Go To Next Section Labeled

"WHILE CRANKING the ENGINE"

TROUBLESHOOTING

Troubleshooting Guide 1

Engine Will Not Start

Checklist - After You Stop Cranking

Indicates the Overspeed limit was exceeded during

starting. Recheck Flywheel Teeth, Overspeed, and

Speed settings. Cycling the power on the IGC will

remove the Overspeed Fault Condition.

Restarting.

IGC is in SETUP Mode. Press and hold the RUN

Button to exit Setup mode. The Fault LED should

turn off. If it doesn't, that means the Overspeed limit

was exceeded during starting.

Teeth, Overspeed, and Speed settings. Cycling the

power on the IGC will remove the Overspeed Fault

Condition. Try Restarting.

Is the battery (+) connected to Terminals A & C? Is

Battery (-) connected to Terminal B? Verify polarity.

Connect

Battery

Recheck Flywheel

Measure

Voltage

Terminals A(+) and B(-) to

verify sufficient Voltage (12V

or 24V). Cycle Power. If still

LED's turn on,

controller

needs

replaced.

Try

across

then