Gage CompuScope 1220 Instrukcja obsługi sprzętu - Strona 9

Przeglądaj online lub pobierz pdf Instrukcja obsługi sprzętu dla Przyrządy pomiarowe Gage CompuScope 1220. Gage CompuScope 1220 17 stron.

Drukuj stronę

CompuScope 1220 specifications

PLEASE CHECK THE GAGE WEBSITE FOR THE MOST UP-TO-DATE SPECIFICATIONS.
SYSTEM REQUIREMENT
PCI-based computer with at least one free full-length PCI slot, 128 MB RAM, 50 MB hard disk and SVGA
video.
SIZE
Plugs into one full-length PCI slot, 13" x 4.1".
1 M Acquisition Memory
4 M Acquisition Memory
8 M Acquisition Memory
64 M Acquisition Memory
256 M Acquisition Memory
512 M Acquisition Memory
1 G Acquisition Memory
POWER (IN WATTS)
+ 5 Volts
Acquisition
Memory
Worst Case
1M
25.0 W
4M
28.0 W
8M
28.0 W
64M
32.5 W
256M
32.5 W
512M
32.5 W
1G
32.5 W
Note: Power connector on the deep memory board of 64M, 256M, 512M and 1G models must also be connected
using a Y-cable.
CHANNELS A & B
Inputs per card:
Impedance:
Coupling:
Connector:
Resolution:
A/D Type:
Input Voltage Ranges:
± 50 mV, ± 100 mV, ± 200 mV, ± 500 mV,
± 1 V, ± 2 V, ± 5 V, ± 10 V
Analog Bandwidth:
CompuScope 1220
1 slot
2 slots
2 slots
3 slots
3 slots
3 slots
3 slots
Typical
17.5 W
20.5 W
20.5 W
23.5 W
23.5 W
23.5 W
23.5 W
2 single-ended inputs
1 MΩ, 35 pF or 50 Ω, software selectable
AC or DC
1 BNC per channel
12 bits
Monolithic, 16 bit oversampling with decimation filter, operating in 12 bit mode
Input Range
-3dB Point
± 10 V
± 5 V
± 2 V
± 1 V
± 500 mV
± 200 mV
± 100 mV
± 50 mV
5 MHz
5 MHz
10 MHz
10 MHz
10 MHz
10 MHz
10 MHz
10 MHz
9