Dynabrade 65014 Instrukcja bezpieczeństwa, obsługi i konserwacji - Strona 8

Przeglądaj online lub pobierz pdf Instrukcja bezpieczeństwa, obsługi i konserwacji dla Szlifierka Dynabrade 65014. Dynabrade 65014 16 stron. Electric tool post grinder 2 inch x 36 inch abrasive belt machine

Drukuj stronę

INSTRUCTIONS FOR USE

Machine Setup

Step 1

Remove any tooling, tooling holders, etc. from the lathe compound.

Step 2

Clear all chips and debris from the top of compound and "T"-slot.

Step 3

Providing the "T"-nut is of correct size for the lathe compound, lift (or hoist) the entire tool into

position. Align and insert "T"-nut into slot.

Step 4

Using your fingers, lightly snug the Hex Screw (97087) until the tool becomes parallel to the

workpiece centerline.

Step 5

The tool can now be swung from side to side and positioned for the desired angle between the

contact wheel and the workpiece. Once this is achieved, firmly tighten Hex Screw (97087).

Step 6

Position the contact wheel at or above the workpiece centerline. This will ensure proper belt

tracking and prevent chatter from occurring. The position can be altered by loosening the two Cap

Screws (97088) and allowing the tool to pivot on the Pivot Shaft (65266) (tool must be supported

while performing this task!) Firmly retighten the screws once proper positioning is achieved.

Step 7

Connect compressed air (Models 64991 &64993).

Step 8

Connect electric power. See page 11.

The machine is now ready for operation.

1/2-13 UNC – 2B

Tapped Hole

SIDE VIEW

4.000

CONTACT WHEEL

2.980

MOUNTING

BLOCK

"T"- Nut Dimensions

2.625

1.000

2.500

.530

1.625

5.625

3/4"

3/8"

1-3/4"

2.000

CONTACT WHEEL

MOUNTING

2.000

Mat'l 303-SS

FRONT VIEW

4.000

BLOCK

6.500

C L