Dynabrade 65014 Посібник з техніки безпеки, експлуатації та обслуговування - Сторінка 8
Переглянути онлайн або завантажити pdf Посібник з техніки безпеки, експлуатації та обслуговування для М'ясорубка Dynabrade 65014. Dynabrade 65014 16 сторінок. Electric tool post grinder 2 inch x 36 inch abrasive belt machine
Друкувати сторінкуINSTRUCTIONS FOR USE
Machine Setup
Step 1
Remove any tooling, tooling holders, etc. from the lathe compound.
Step 2
Clear all chips and debris from the top of compound and "T"-slot.
Step 3
Providing the "T"-nut is of correct size for the lathe compound, lift (or hoist) the entire tool into
position. Align and insert "T"-nut into slot.
Step 4
Using your fingers, lightly snug the Hex Screw (97087) until the tool becomes parallel to the
workpiece centerline.
Step 5
The tool can now be swung from side to side and positioned for the desired angle between the
contact wheel and the workpiece. Once this is achieved, firmly tighten Hex Screw (97087).
Step 6
Position the contact wheel at or above the workpiece centerline. This will ensure proper belt
tracking and prevent chatter from occurring. The position can be altered by loosening the two Cap
Screws (97088) and allowing the tool to pivot on the Pivot Shaft (65266) (tool must be supported
while performing this task!) Firmly retighten the screws once proper positioning is achieved.
Step 7
Connect compressed air (Models 64991 &64993).
Step 8
Connect electric power. See page 11.
The machine is now ready for operation.
1/2-13 UNC – 2B
Tapped Hole
SIDE VIEW
4.000
CONTACT WHEEL
2.980
MOUNTING
BLOCK
"T"- Nut Dimensions
2.625
1.000
2.500
.530
1.625
5.625
1"
3/4"
3/8"
1-3/4"
2.000
CONTACT WHEEL
MOUNTING
2.000
8
Mat'l 303-SS
FRONT VIEW
4.000
BLOCK
6.500
C L