GREAT PLAINS Yield-Pro 3P4025AH Instrukcja regulacji w terenie - Strona 3

Przeglądaj online lub pobierz pdf Instrukcja regulacji w terenie dla Sprzęt rolniczy GREAT PLAINS Yield-Pro 3P4025AH. GREAT PLAINS Yield-Pro 3P4025AH 6 stron. 3-point stack-fold air-pro planter
Również dla GREAT PLAINS Yield-Pro 3P4025AH: Instrukcja instalacji (7 strony)

Drukuj stronę

Initial Planter Height:

The planter is designed to operate with the main tool bar 26

inches above the planting surface.

1) Completely lower the 3-point hitch along with the lift-assist

cylinders. If necessary, first raise the lift-assist cylinders off of

the transport locks and remove them.

2) Raise the 3-point hitch until the tool bar is 26 inches above

the planting surface. Set the 3-point lever stop in the tractor for

future reference.

3) Place a level on the center frame and slowly begin to raise

the lift-assist cylinders until the frame is level.

4) Ensure that the tool bar still measures 26 inches and insert

depth blocks (5) on to the lift-assist cylinders. This will act as a

depth stop during field operation.

Leveling The Wings:

Ensure that the center section of the planter is level before

adjusting the outer wings.

tool bar to determine what adjustment needs to be made.

1) Loosen the jam nut (6) at the upper link adjustment arm.

2) Remove the bolt (7) and slide the locking plate (8) away

from the adjustment nut.

3) Rotate the adjustment (9) until the wing is level.

4) Secure the jam nut and re-install the locking plate.

the wings are adjusted, it may be necessary to adjust the

gauge wheel also.

Gauge Wheel Tension:

Note: Prior to adjusting the gauge wheels, the planters center

and wing sections must be level and aligned along with the

tool bar height set at 26 inches from the ground.

1) Unfold the planter onto a level surface.

2) Raise the planter so that the gauge wheels are just off the

ground.

3) Loosen the top nut (10) just above the yoke block.

4) Raise of lower the planter so that the base of the tool bar is

26 inches from the ground.

5) Using an open-ended wrench or adjustable wrench at the

integral hex nut (11), rotate the link until the spring is just

touching the yoke block with neither gap nor compression.

6) Re-tighten the top nut (10).

Note: Place a level on the wings

48778

48779

Note: If

48780

48926

3 of 6

26"

Document

#PLUS300C-0002A