GREAT PLANES EP F-20 Tigershark ElectriFLy Instrukcja obsługi - Strona 11
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Zabawka GREAT PLANES EP F-20 Tigershark ElectriFLy. GREAT PLANES EP F-20 Tigershark ElectriFLy 16 stron.
Drukuj stronę
❏
4. Install the tail cone. Use cellophane tape (household
tape) to secure it to the hatch and the fuselage. If you choose
to use glue, R/C-56 Glue (JOZR5007) will allow easy removal
of the hatch in the future. Medium CA is also acceptable, but
only if two small drops are used 180° apart from each other.
GET THE MODEL READY TO FLY
❏
1. Stick the hook side of the 4" [102mm] piece of hook and
loop material to the battery tray in the location shown.
❏
2. Locate the parts to assemble the foam display stand. There
should be two side braces, two top braces (small), two bottom
braces (large), and two interlocking supports. Note: The foam
display stand is not made of AeroCell
CA adhesive can be used. Regular CA will melt the foam.
❏
3. Assemble the stand by fi rst interlocking the supports
and then adding the two vertical side braces. Add the top
and bottom lateral braces next. The top braces are smaller
to allow the aileron servos and linkages to clear.
❏
4. Apply the pre-cut decals, using the box photos as a
guide for placement
Check the Control Directions
❏
1. Turn on the transmitter and receiver and center the
trims. If necessary, remove the servo arms from the servos
and reposition them so they are centered. Reinstall the
screws that hold on the servo arms.
❏
2. With the transmitter and receiver still on, check all the
control surfaces to see if they are centered. If necessary,
adjust the screw-lock pushrod connectors to center the
control surfaces.
3-CHANNEL
RADIO SET UP
(STANDARD MODE 2)
FULL
THROTTLE
❏
3. Make certain that the control surfaces and the ESC
respond in the correct direction as shown in the diagram.
If any of the controls respond in the wrong direction, use
the servo reversing in the transmitter to reverse the servos
connected to those controls. Be certain the control surfaces
have remained centered. Adjust if necessary.
11
™
foam. Only foam-safe
RIGHT AILERON
MOVES UP
LEFT AILERON
MOVES DOWN
ELEVATOR
MOVES DOWN