GREAT PLANES HeadWind "B" Instrukcja obsługi - Strona 7

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Zabawka GREAT PLANES HeadWind "B". GREAT PLANES HeadWind "B" 16 stron. Park flyers series

4. Remove the covering from the control horn slot on the

left side of the rudder.

5. Glue the rudder control into the slot with medium CA.

6. The bottom of the horizontal stab has the large gap for

the elevator hinge. Place the stab upside-down on your work

bench. Mark the inside end of the right elevator 1/4" [5mm]

that is perpendicular to the elevator's leading edge, and that

runs from behind the leading edge to the trailing of the stab.

Carefully trim the inner edge off the elevator as shown.

7. Glue the elevator control horn in place with medium

CA. Note: The removed piece can be shaped and glued to

the other side of the control horn for appearance if you

desire, but it is not necessary.

8. Center and align the TE of the stab with the TE of the

fuse. Pin the front center of the stab to the center of the fuse.

Note: Folding the elevator up makes aligning the TEs with

each other easier.

9. Attach a string to the wing dowel and pull it back to the

left corner of the stab. Mark the string at that location on a

piece of tape. Move the end of the string to the other side of

the stab. Rotate the stab until both lengths are the same. Pin

the TE of the stab to the fuse.