GREAT PLANES HeadWind "B" Instrukcja obsługi - Strona 8

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Zabawka GREAT PLANES HeadWind "B". GREAT PLANES HeadWind "B" 16 stron. Park flyers series

10. Using a felt-tip pen, mark the covering on the bottom

of the stab where it contacts the fuse. Also mark the top of

the fuse along the LE of the stab. Note: Be careful not to cut

into the balsa stab when removing the covering.

11. Remove the stab. Cut the covering from the marked

area of the stab and from the mark on the top of the fuse to

the rear of the stab saddle.

12. Mount the wing to the fuse with two long rubber

bands. Pin the stab to the fuse. Lift the stab off, and coat the

stab and fuse with epoxy. Reinstall the stab with the pin for

guidance. Checking from behind the aircraft to make sure

the stab is parallel with the wing, epoxy the stab in place.

13. Center the fin on the stab and align it with the center

of the fuse. Mark the stab on both sides of the base of the

fin. Remove the covering from the marked area of the top of

the stab and the bottom of the fin. Note: Be careful not to cut

into the balsa stab when removing the covering.

14. Glue the fin to the stab, making sure to keep it aligned

with the centerline of the fuse and perpendicular to the stab.