Dynacord AM 12 Instrukcja obsługi - Strona 5

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla System głośników Dynacord AM 12. Dynacord AM 12 12 stron. 360 w high efficiency 2 way active cabinet

Drukuj stronę

C O N T R O L S

MIC

is an electronically balanced XLR-type input for connecting

low-impedance microphones. Basically, you are able to con-

nect any type of microphone to this input as long as you mind

the correct pin-assignment. It is also possible to connect con-

denser microphones, which automatically gets the needed

phantom power (+24V) from the AM12. Please also refer to

your microphone's owner's manual for additional information.

Caution: Before connecting or unplugging a microphone,

make sure to turn the GAIN control all the way down

(counterclockwise). This helps to protect the audience and

you from unpleasing knack noise.

The MIC-input is not necessarily meant for the connection of

mixers, keyboard instruments or other electronic sound gene-

rating sources. For better results, please use the den LIN-input

instead.

MIC GAIN

This control is used to set the volume of the connected micro-

phone within an adjustment range of -∞ to +40dB.

Caution: Extremely high volume setting may result in

unpleasing feedback noise!

LINE IN

is an electronically balanced input for connecting high-impe-

dance audio signal sources like mixers, electronic music instru-

ments like keyboards, guitars and bass guitars with built-in

active electronics. It is possible to connect balanced as well as

unbalanced gear at the LINE-input using monaural or stereo

phone plug cables. Balanced connection via stereo phone plug

cables is preferable whenever the source unit has a balanced

output stage. Following this advice will provide you with the

advantage of less interference that is introduced from external

hum of HF-induction.

Caution: Before connecting or unplugging devices, make

sure to turn the LINE TRIM control all the way down

(counterclockwise). This helps to protect the audience and

you from unpleasing knack noise.

LINE OUT

The LINE OUT socket provides the carried through audio

signal from the LINE IN connector. It can be used to feed

additional external equipment (e.g. an additional AM12) with

the identical input signal.

LINE TRIM

This control serves for setting the input level of the signal

source that is connected to LINE IN within an adjustment range

of -∞ to +6dB.