Dynacord AM 12 Manual do Proprietário - Página 5
Procurar online ou descarregar pdf Manual do Proprietário para Sistema de altifalantes Dynacord AM 12. Dynacord AM 12 12 páginas. 360 w high efficiency 2 way active cabinet
Imprimir página
C O N T R O L S
MIC
is an electronically balanced XLR-type input for connecting
low-impedance microphones. Basically, you are able to con-
nect any type of microphone to this input as long as you mind
the correct pin-assignment. It is also possible to connect con-
denser microphones, which automatically gets the needed
phantom power (+24V) from the AM12. Please also refer to
your microphone's owner's manual for additional information.
Caution: Before connecting or unplugging a microphone,
make sure to turn the GAIN control all the way down
(counterclockwise). This helps to protect the audience and
you from unpleasing knack noise.
The MIC-input is not necessarily meant for the connection of
mixers, keyboard instruments or other electronic sound gene-
rating sources. For better results, please use the den LIN-input
instead.
MIC GAIN
This control is used to set the volume of the connected micro-
phone within an adjustment range of -∞ to +40dB.
Caution: Extremely high volume setting may result in
unpleasing feedback noise!
LINE IN
is an electronically balanced input for connecting high-impe-
dance audio signal sources like mixers, electronic music instru-
ments like keyboards, guitars and bass guitars with built-in
active electronics. It is possible to connect balanced as well as
unbalanced gear at the LINE-input using monaural or stereo
phone plug cables. Balanced connection via stereo phone plug
cables is preferable whenever the source unit has a balanced
output stage. Following this advice will provide you with the
advantage of less interference that is introduced from external
hum of HF-induction.
Caution: Before connecting or unplugging devices, make
sure to turn the LINE TRIM control all the way down
(counterclockwise). This helps to protect the audience and
you from unpleasing knack noise.
LINE OUT
The LINE OUT socket provides the carried through audio
signal from the LINE IN connector. It can be used to feed
additional external equipment (e.g. an additional AM12) with
the identical input signal.
LINE TRIM
This control serves for setting the input level of the signal
source that is connected to LINE IN within an adjustment range
of -∞ to +6dB.
12