Emergi-Lite Provider Series Podręcznik
Przeglądaj online lub pobierz pdf Podręcznik dla Sprzęt oświetleniowy Emergi-Lite Provider Series. Emergi-Lite Provider Series 2 stron. Emergency lighting
Drukuj stronęProvider Series - Emergency lighting
6 volt
Disconnect Power before Installation.
IMPORTANT SAFEGUARDS
When using electrical equipment, basic safety precautions should always be fol-
lowed including the following:
READ AND FOLLOW ALL SAFETY
INSTRUCTIONS
1.
All servicing should be performed by qualified service personnel.
2.
All unused wires must be insulated to prevent shorting.
3.
Do not use outdoors.
4.
Do not let power supply cords touch hot surfaces.
5.
Do not mount near gas or electric heaters.
6.
Use caution when handling batteries. Avoid possible shorting.
7.
Equipment should be mounted in locations and at heights where it will not readily
be subjected to tampering by unauthorized personnel.
8.
The use of accessory equipment not recommended by the manufacturer may
cause an unsafe condition.
9.
Do not use this equipment for other than intended use.
10.
Unit to be installed only as per configuration described in this instruction manual.
SAVE THESE INSTRUCTIONS
Installation Instructions
Install fixture/lamp type combination no higher than
the maximum mounting heights as stipulated in the
IMPORTANT:
"Lamp Mounting Height Cross-reference Table" (P/N
750.1924). Refer to "Technical Information" section of
our website.
1. Turn off AC power.
2. Route AC unswitched circuit of rated voltage into junction box and leave 6" of wire
length.
3. Remove the backplate by pressing on the tabs (see fig. 2) with a screwdriver.
4. Locate the AC connector (if applicable) and attach to the AC circuit.
Refer to step 7.
5. Determine the desired position of the test switch (see fig. 5) before mounting
the backplate.
6. Choose the proper mounting solution below and continue to step 7.
NOTE: For units with a safety wire, install the safety wire (see figure 1), after installing
the back plate, as a means to support the unit while making connections. Insert one
of the screws, used for fixing the backplate to the mounting surface or junction box,
through the lug on the end of the safety wire before screwing it in place.
a. Junction box mounting
Knock out the proper hole pattern in the back cover to mount to a standard
junction box. Route the AC supply leads or connector through the large
knockout and mount the backplate to the junction box (see fig. 3a).
b. Ceiling mount
DO NOT install unit to the ceiling unless its model number
CAUTION:
includes the suffix "CM".
For installation instructions refer to the addendum for ceiling mount.
Emergi-Lite®
Tel: (888) 552-6467
®
WARNING:
Risk of Shock.
Fax: (800) 316-4515
Provider Series - Emergency lighting
1
4
2
Figure 1
Parts List
1. Backplate
2. Housing
3. Clear lens
4. Safety wire (not available
for all units)
Pry here, under the cover,
with a screwdriver
Figure 2
Junction box mounting
Figure 3a
Conduit hole
to knock out
Figure 3b
www.emergi-lite.com
Use flexible
conduit only
5
6
3
5. Securement screw(ceiling
mount)
6. AC connector (not avail-
able for all units)
Tabs
09/16 750.1705 Rev. E
1/2