GreatWhite GW9500 Instrukcja obsługi - Strona 3
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Odkurzacz basenowy GreatWhite GW9500. GreatWhite GW9500 12 stron. Automatic pool cleaner
Drukuj stronęPlease use the convenient, water resistant, "EASY-STEPS" card.
Figure 1
Vacuum
Regulator
w/2 Caps
8'
24'
Figure 2
Figure 3
Swivel
Assembly
Figure 5
Hose Cuff
marked
"Connect
to Cleaner"
Figure 7
1875 0795
ABOUT INSTALLATION
1882 0795
Reducer
Cone
Cleaner
Swivel
Ass'y
Hose
1881 0795
Skimmer
Vac
Port
1880 07
Figure 4
Figure 6
White Plastic
Vacuum Regulator
White Rubber
Reducer Cone
Step 1: Straighten hose (Figure 1)
Remove and uncoil the hose from the carton. Lay it out
in the sunlight, flat and straight.
Step 2: Check parts (Figure 2)
Cleaner, black plastic swivel assembly, white rubber
reducer cone, one 24' and two 8' hoses, white plastic
vacuum regulator, extra black regulator cap marked
"50".
Step 3: Clean filter system (Figure 3)
Backwash and clean filter; rinse; clean all baskets, etc.
Start pump.
Step 4: Adjust valves for vacuuming (Figure 4)
Decide on the vacuum connection you are going to use
(either a skimmer or a dedicated wall fitting) and adjust
the pump valves (if your system has valves) to direct all
vacuum there.
Close the main drain (also see "About Fine Tuning the
Vacuum", Page 4)
Step 5: Assemble cleaner (Figure 5)
Insert swivel assembly into cleaner; twist 1/4 turn.
Step 6: Measure hose length needed (Figure 6)
Before connecting the hose, lay it out from the vacuum
connection you are using (whether skimmer or dedicat-
ed wall fitting) to the furthest point of the pool. The
hose should be at least 4' longer than this. More than 4'
longer is OK. Do not cut the hose.
Step 7: Connect hose to cleaner (Figure 7)
Connect the 24' hose end marked "connect to cleaner"
to the black swivel assembly. Connect the white plastic
vacuum regulator to the opposite end of the hose. Insert
the regulator into the white rubber reducer cone.
Step 8: Connect hose to filter system (Figure 8)
Fill the cleaner and hose with water and connect to the
suction source. The cleaner will begin to operate.
Figure 8
3