GreatWhite GW9500 Manual do Proprietário - Página 3

Procurar online ou descarregar pdf Manual do Proprietário para Aspirador de piscinas GreatWhite GW9500. GreatWhite GW9500 12 páginas. Automatic pool cleaner

Imprimir página

Please use the convenient, water resistant, "EASY-STEPS" card.

Figure 1

Vacuum

Regulator

w/2 Caps

24'

Figure 2

Figure 3

Swivel

Assembly

Figure 5

Hose Cuff

marked

"Connect

to Cleaner"

Figure 7

1875 0795

ABOUT INSTALLATION

1882 0795

Reducer

Cone

Cleaner

Swivel

Ass'y

Hose

1881 0795

Skimmer

Vac

Port

1880 07

Figure 4

Figure 6

White Plastic

Vacuum Regulator

White Rubber

Reducer Cone

Step 1: Straighten hose (Figure 1)

Remove and uncoil the hose from the carton. Lay it out

in the sunlight, flat and straight.

Step 2: Check parts (Figure 2)

Cleaner, black plastic swivel assembly, white rubber

reducer cone, one 24' and two 8' hoses, white plastic

vacuum regulator, extra black regulator cap marked

"50".

Step 3: Clean filter system (Figure 3)

Backwash and clean filter; rinse; clean all baskets, etc.

Start pump.

Step 4: Adjust valves for vacuuming (Figure 4)

Decide on the vacuum connection you are going to use

(either a skimmer or a dedicated wall fitting) and adjust

the pump valves (if your system has valves) to direct all

vacuum there.

Close the main drain (also see "About Fine Tuning the

Vacuum", Page 4)

Step 5: Assemble cleaner (Figure 5)

Insert swivel assembly into cleaner; twist 1/4 turn.

Step 6: Measure hose length needed (Figure 6)

Before connecting the hose, lay it out from the vacuum

connection you are using (whether skimmer or dedicat-

ed wall fitting) to the furthest point of the pool. The

hose should be at least 4' longer than this. More than 4'

longer is OK. Do not cut the hose.

Step 7: Connect hose to cleaner (Figure 7)

Connect the 24' hose end marked "connect to cleaner"

to the black swivel assembly. Connect the white plastic

vacuum regulator to the opposite end of the hose. Insert

the regulator into the white rubber reducer cone.

Step 8: Connect hose to filter system (Figure 8)

Fill the cleaner and hose with water and connect to the

suction source. The cleaner will begin to operate.

Figure 8