Dynalink 56K e-modem II Podręcznik szybkiej konfiguracji - Strona 3

Przeglądaj online lub pobierz pdf Podręcznik szybkiej konfiguracji dla Router sieciowy Dynalink 56K e-modem II. Dynalink 56K e-modem II 6 stron.

Connect the modem to your PC

1. Turn your PC OFF.

2. Connect the grey serial cable to both the modem and a spare COM port found

on the back of the PC.

3. Connect the enclosed phone cable to the modem LINE jack and a phone wall socket.

4. Connect the Power Supply Unit to the modem and a power point.

5. Turn the modem on – the green power light should light up.

Install the modem drivers

1. Power ON your PC.

2. Windows "Plug & Play" will detect the modem and attempt to install the modem's

drivers. If the modem is not detected, please refer to the Troubleshooting section.

3. Point Windows to this CD.

4. Please continue to follow the on-screen prompts as Windows guides you through

the remainder of the modem installation.

5. After the drivers have been installed power the modem off and then on.

Country selection

1. Click Start – Settings – Control Panel

2. Double-click the Modem Regional Settings icon.

3. Wait a few moments then select your country from the drop-down menu.

4. Click OK. Click OK again when finished.

Check the modem can talk to the pc

Windows XP & 2000 users:

1. Click Start – Settings – Control Panel – Phone and Modem Options – Modems.

2. You will see the modem listed next to a COM Port. Note down the COM port

number in this box [

3. Click Properties – Diagnostics – Query Modem. If a table of ATI responses is

reported, then the modem and computer are communicating. If a table is not

reported, but instead an error message such as CANNOT OPEN PORT, please

refer to the Troubleshooting section.

Windows 95, 98 & ME users:

1. Click Start – Settings – Control Panel – Modems – Diagnostics.