Hideawaybeds alpha bed SBF Instrukcja montażu - Strona 13
Przeglądaj online lub pobierz pdf Instrukcja montażu dla Wyposażenie wnętrz Hideawaybeds alpha bed SBF. Hideawaybeds alpha bed SBF 18 stron. Steel bed frame
Drukuj stronęSTEP 5: Assemble Steel Bed Frame to Face Panels, continued
1:
Lay the Bed Face Panels down on a non-scratch surface such as a carpet or
blanket.
2:
Completely assemble the 4 Frame Sections with the corner brackets and the
3/16"x1/2" (M5x12mm) black bolts provided. Refer to Drawing 12 to properly place
the leg stops at outer right and left bottom holes at the foot of the bed frame.
3:
Position the bed frame on the bed face panels. With the Head Frame section
flush with the head end of the Bed Face Panels. Refer to Drawing 10. Carefully
attach the Bed Frame so it is centered on the Bed Face Panels; you will have
approximately 15/16" (24mm) space from the bed frame to the panel edges right and
left and at the bed foot.
Note: It is very important to have the Bed Frame centered on the Bed Face Panels.
Any error will be noticed in the vertical sight lines when the bed is closed.
4:
Three steel stiffeners are provided for all beds. These notched stiffeners
should be located and attached to divide the Bed Face length into four equal
sections. Use caution not to damage raised panels by putting screws in recessed
areas.
5:
Attach the Nylon Web Strap approximately 18" (460mm) down from the foot of the
bed and 6" (150mm) in from the sides, for tucking in sheets. The Straps help secure
the mattress in the vertical position (see drawing 10).
STEP 6: Set the Lift Mechanism
Drawing 13.
Holding one foot against the bottom front edge of the side panel and using the 13"
(330mm) PVC tube, lever the tension arm out until you can set the arm lock to the hex
nut at the hole A (see drawing 13.). This is the hex nut at the top front corner of the
mechanism.
Caution:
If possible have a helper assist in the setting of the mechanism and loading of the bed
face panel. DO NOT reach behind the tension arm when you are doing the setting
procedure.
Bolt in Hole #3 Drops
into this slot when Bed
Face Panel is loaded
Tension Arm
Bolt through Hole #2 to secure
Arm Lock
Hexagon Nut (Hole "A")
Notch to rest against head of
Allen Bolt in Hole #1
13