Hideawaybeds alpha bed SBF Montaj Talimatları Kılavuzu - Sayfa 13

İç Mekan Mobilyaları Hideawaybeds alpha bed SBF için çevrimiçi göz atın veya pdf Montaj Talimatları Kılavuzu indirin. Hideawaybeds alpha bed SBF 18 sayfaları. Steel bed frame

Sayfayı Yazdır

STEP 5: Assemble Steel Bed Frame to Face Panels, continued

Lay the Bed Face Panels down on a non-scratch surface such as a carpet or

blanket.

Completely assemble the 4 Frame Sections with the corner brackets and the

3/16"x1/2" (M5x12mm) black bolts provided. Refer to Drawing 12 to properly place

the leg stops at outer right and left bottom holes at the foot of the bed frame.

Position the bed frame on the bed face panels. With the Head Frame section

flush with the head end of the Bed Face Panels. Refer to Drawing 10. Carefully

attach the Bed Frame so it is centered on the Bed Face Panels; you will have

approximately 15/16" (24mm) space from the bed frame to the panel edges right and

left and at the bed foot.

Note: It is very important to have the Bed Frame centered on the Bed Face Panels.

Any error will be noticed in the vertical sight lines when the bed is closed.

Three steel stiffeners are provided for all beds. These notched stiffeners

should be located and attached to divide the Bed Face length into four equal

sections. Use caution not to damage raised panels by putting screws in recessed

areas.

Attach the Nylon Web Strap approximately 18" (460mm) down from the foot of the

bed and 6" (150mm) in from the sides, for tucking in sheets. The Straps help secure

the mattress in the vertical position (see drawing 10).

STEP 6: Set the Lift Mechanism

Drawing 13.

Holding one foot against the bottom front edge of the side panel and using the 13"

(330mm) PVC tube, lever the tension arm out until you can set the arm lock to the hex

nut at the hole A (see drawing 13.). This is the hex nut at the top front corner of the

mechanism.

Caution:

If possible have a helper assist in the setting of the mechanism and loading of the bed

face panel. DO NOT reach behind the tension arm when you are doing the setting

procedure.

Bolt in Hole #3 Drops

into this slot when Bed

Face Panel is loaded

Tension Arm

Bolt through Hole #2 to secure

Arm Lock

Hexagon Nut (Hole "A")

Notch to rest against head of

Allen Bolt in Hole #1