ADEMCO 4192CP Instalacja i konserwacja - Strona 2
Przeglądaj online lub pobierz pdf Instalacja i konserwacja dla Alarm dymowy ADEMCO 4192CP. ADEMCO 4192CP 4 stron. Addressable ionization smoke detector
Drukuj stronęFor signal witing (the widng bet~een inlercQnnected detectors),, it is recom~ended that the wire be no
smaller !hani8gauge(l.Omm
). Wire sizes "pto12ga"ge
w#re(2,5mm ) maybe used.
For best system performance the power (+) and power (-) loop wires should be twisted pair and installed
in separate gro"n,ded co,nd"it orsmelded cable to protect the Ioopfrom extraneous electrical intedere"ce.
It? cable s~eld, IS provided, the s~eld Connecffo" to and I,om the base mUSIbe CQntinUO"S by using
wire nuts, crimping, or soldering as appropriate for a rehable connection,
Wre connections are made by simply stripping about 3/6 of insulation from the end of the wire sliting
the bare endolthe wire under theclamping plate, andtightenhg theclamping plate screw. Donot loop
the wire under the clamping plate.
The zone witing of the detector should be checked for continuity, polarity, and dielectric tests
SETTING THE I.D. NUMBER FOR THE MODEL 4192CP DETECTOR
Beforelnstalling the Mode14192CP, itmustbeassi
nedanldentifica ffonnumber byarrangingthe DIP
t
switch on the bottom of th@unit. Assign the num er (allocated in the control system programming
worksheet) accordng to the chafl below.
~.--...l
AD400.03.00
2
156-390.00