ADEMCO 4192CP Kurulum ve Bakım - Sayfa 2

Duman Alarmı ADEMCO 4192CP için çevrimiçi göz atın veya pdf Kurulum ve Bakım indirin. ADEMCO 4192CP 4 sayfaları. Addressable ionization smoke detector

Sayfayı Yazdır

For signal witing (the widng bet~een inlercQnnected detectors),, it is recom~ended that the wire be no

smaller !hani8gauge(l.Omm

). Wire sizes "pto12ga"ge

w#re(2,5mm ) maybe used.

For best system performance the power (+) and power (-) loop wires should be twisted pair and installed

in separate gro"n,ded co,nd"it orsmelded cable to protect the Ioopfrom extraneous electrical intedere"ce.

It? cable s~eld, IS provided, the s~eld Connecffo" to and I,om the base mUSIbe CQntinUO"S by using

wire nuts, crimping, or soldering as appropriate for a rehable connection,

Wre connections are made by simply stripping about 3/6 of insulation from the end of the wire sliting

the bare endolthe wire under theclamping plate, andtightenhg theclamping plate screw. Donot loop

the wire under the clamping plate.

The zone witing of the detector should be checked for continuity, polarity, and dielectric tests

SETTING THE I.D. NUMBER FOR THE MODEL 4192CP DETECTOR

Beforelnstalling the Mode14192CP, itmustbeassi

nedanldentifica ffonnumber byarrangingthe DIP

switch on the bottom of th@unit. Assign the num er (allocated in the control system programming

worksheet) accordng to the chafl below.

~.--...l

AD400.03.00

156-390.00