Airdream Prestige DL Annex Instrukcja użytkownika - Strona 2

Przeglądaj online lub pobierz pdf Instrukcja użytkownika dla Akcesoria Airdream Prestige DL Annex. Airdream Prestige DL Annex 8 stron. Inflatable

Erecting your Inflatable Awning

Before you unpack your awning we strongly advise that you place a groundsheet

in front of the caravan. This will avoid any soiling of the fabric or penetration by

stones or twigs. Erecting the awning is a relatively simple task and we trust the

following information will be of valuable assistance to the new camper.

However we would advise the inexperienced camper to seek advice from the

dealer.

1. Always site your awning on a flat piece of ground this will enable you to obtain

the best possible fit of your awning.

2. Check that your awning rail is clean and free from any sharp edges which could

easily damage the fabric or awning beading.

3. You are now ready to start erecting your awning. To make the task easier we

would always suggest that two people will make erecting the awning a much

easier task.

4. Start by threading the white/grey beading into the awning rail with one person

pulling the awning through the rail. The other person should be feeding the

beading into the rail ensuring that it runs smoothly. Position the awning so that

it clears windows, doors, etc. Secure the awning in the correct position by

pegging out the four corner tabs. Attach the inflator to the inflation valve; inflate

to an optimal pressure of 7-8psi.

During the latter part of inflation it may be necessary to lift the tubes into the

correct position. When you have inflated to the correct pressure disconnect the

inflator ensuring that you have securely tightened the valve cap. Be careful not to

cross thread this cap.

2/8