Aire Spring Haven 04612 Instrukcja obsługi - Strona 15

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Wentylator Aire Spring Haven 04612. Aire Spring Haven 04612 16 stron.

TROUBLESHOOTING

SYMPTOM

SOLUTION

Fan will not start

Fan Sounds Noisy

Fan Wobble

Lights shut off and

will not come back on

Fans/Light Turn On

and Off Unexpectedly

Check to make sure the wall switch is turned on.

Check circuit fuses or breakers.

Caution! Make sure the power is turned off before performing the following steps.

Remove canopy and check wire connections.

Check wall control transmitter connections (if applicable).

Note: Fan must be installed at a maximum distance of 40 feet from the transmitting unit

for proper signal transmission between the transmitting unit and the fan's receiving unit.

Allow a 24-hour "break in" period. Most noises associated with a new fan will go away

during this time.

Make sure the screws that attach the fan blade holder to the motor hub is tight.

Make sure outlet box is secured to building structure, if necessary use the wood screws

provided to further secure outlet box to joist.

Make sure hanger bracket is secure to the outlet box, screws are tight.

NOTE: All blade sets are grouped by weight. Because wood and plastic blades vary in

density, the fan may wobble even though blades are matched.

Make sure outlet box is secured to building structure, if necessary use the wood screws

provided to further secure outlet box to joist.

Make sure hanger bracket is secure to the outlet box, screws are tight.

If a Balancing kit is provided follow the instructions included with the balancing kit to

help correct any excessive wobble.

This unit is equipped with a wattage limiting device. Lamping in excess of 190 watts will

disable your ceiling fan's light kit. To reset your light kit you must turn the power off and

re lamp, keeping the wattage under 190 watts. Restore power to your ceiling fan and

continue normal operation.

This is caused by interference, Please see "Frequency interference" for steps to change

the frequency.