ADEN POWERKIT GO Instrukcja obsługi i montażu - Strona 11

Przeglądaj online lub pobierz pdf Instrukcja obsługi i montażu dla Akcesoria rowerowe ADEN POWERKIT GO. ADEN POWERKIT GO 16 stron.

POWERPACK — ASSEMBLY INSTRUCTIONS

To attach the mounting plate, the threads provided for the bottle holder on the bike should be used, if

available. The position on the frame can be freely selected by using the existing holes in the mounting plate.

Make sure, however, that you have enough space at the bottom to keep the motor plug free and that there is

enough space at the top to be able to easily remove the battery.

An alternative fastening option, if there are no screw-in points, is to use the tensioning straps. These are not

included in the scope of delivery of the standard set, but can be ordered from ADEN on request.

No holes may be drilled in very light / thin-walled frames and especially frames made of composite materials

(carbon frames). In this case, the mounting plate may ONLY be attached to the frame using the additional

straps. Otherwise frame breaks, falls and serious injuries can result.

ADEN GmbH

ASSEMBLY

Assembly

POWERPACK contains: POWERPACK battery, mounting plate

including fastening screws, charger

Mount the mounting plate on the frame (bottle holder thread) using

the screws provided.

Mask the frame with the protective film provided on the contact

surfaces.

On bikes with full suspension, make sure that the damper does

not hit the battery when it is compressed.

Press the battery onto the mounting plate and make sure that it

sits correctly in the guide, then tighten the grub screw with a Allen

key size 3.

www.aden-sports.com

EN | P. 11