ADEN POWERKIT GO Instrukcja obsługi i montażu - Strona 9

Przeglądaj online lub pobierz pdf Instrukcja obsługi i montażu dla Akcesoria rowerowe ADEN POWERKIT GO. ADEN POWERKIT GO 16 stron.

POWERKIT GO — ASSEMBLY INSTRUCTIONS

ADEN GmbH

ASSEMBLY

Now the motor will be attached to the chain stay using the pre-

assembled motor bracket.

To do this, turn the drive unit clockwise until the motor holder rests

on the chain stay.

Now put the belt around the chain stay and insert it into the lower

slot of the motor mount.

Assembly-Note:

The Velcro should be stretched as tight as possible.

If possible, place the supplied frame protection under the motor

mount to protect the frame.

To align the motor holder, turn the rear wheel two turns and then

tighten the clamping screw with a size 4 Allen key (approx. 3Nm)

Attention:

The maximum diameter for disc brakes is 20,3cm, if a larger brake

disc is used, the motor would rub against the brake disc.

The assembly of the pedal sensor follows.

First the magnet is pressed against the pedal axle.

Assembly-Note:

Make sure that the area between the magnet and the pedal

axis is clean.

Press the 2nd magnet on the pedal axle on the right side, so

you always have a replacement with you!

The pedal sensor must be placed in such a way that the pedal

axis passes the pedal sensor in the middle when the crank is

turned.

The distance between the pedal sensor and the magnet must

be approx. 1 cm.

The pedal sensor is fixed to the frame with the supplied

adhesive strip and additionally secured with an adhesive tape.

Attention:

Without a correct signal from the pedal sensor, the motor will NOT

work!

Assembly-Note:

The sensor can also be mounted on top of the chain stay.

Magnet and sensor must be kept clean in order to function

properly.

www.aden-sports.com

EN | P. 9