Dynamite DYN4064 Instrukcja obsługi - Strona 5

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Ładowarka Dynamite DYN4064. Dynamite DYN4064 20 stron. Passport ultra ac/dc charger cycler

Drukuj stronę

input Power Connection

NOTE: Do not connect both AC and DC input

power types to the charger simultaneously or

damage to the charger may occur.

aC Voltage

Connect the 100–240 AC input power cord to

the appropriate power receptacle.

DC Voltage

Connect the red alligator clip to the positive (+)

terminal of a 11–18-volt DC power supply or

battery. Connect the black alligator clip to the

negative (-) terminal.

Charge output Battery Connection

Choose the appropriate charge cord to match

your battery pack and connect the positive (red)

lead to the positive (+) output terminal. Connect

the negative (black) lead to the negative (-)

output terminal.

Charge Mode

A. Set the current rate before charging.

Adjustable charge rates from 0.1–8A.

(Current rates can be adjusted by pressing

the START button during charging.)

B. See the table below to select the charge

rate for Ni-Cd and Ni-MH battery packs.

We recommend that you charge 1800mAh

receiver packs at 1.8A(1C).

Battery Capacity Charge Rate

600mAh

1300mAh

1800mAh

3300mAh

C. It is normal for the current rate to drop to

0 then resume during Ni-MH and Ni-Cd

charging.

D. A completely discharged Li-Po or Li-Fe

battery pack can be fully recharged in

approximately 2–3 hours with charge rate at

1C.

Dynamite Ultra AC/DC Charger/Cycler

Charge Time

0.6A

60–80 Min.

78–94 Min.

54–65 Min.

40–48 Min.

E. The built-in cooling fan will automatically

engage during charge and discharge functions.

F. Press the START button to return to the

previous menu after charging.

G. Press and hold the START button for 3

seconds to restart the charging process. This

same process is used to start the discharge

and cycling modes.

Discharge Mode

A. The discharge rate can be adjusted from

0.1–5A. Reset the current rate by pressing

the START button during discharge.

B. When discharging Ni-MH and Ni-Cd

batteries, the minimum discharge voltage

should not be set lower than .8 volts/cell

(e.g. the cutoff voltage for a 6-cell pack is

4.8V (.8*6)).

Discharge/Charge Cycle Mode

A. Set three parameters: discharge current,

discharge voltage and charge current.

B. Press and hold the START button for 3

seconds to start.

NOTE: This mode is only suitable for Ni-Cd or

Ni-MH battery, and could be set to 10 cycles

(max).

operating instructions

A. Press the MODE button to change from the

main menu to the setting menu. Rotating

the dial in the main menu lists all options

available for the battery chemistry shown

on the screen. Rotating the dial while in the

settings menu lists menus that allow changes

to the chargers functionality unrelated to the

battery type.

B. Press the START button to change the

selected menu.

C. Press START to confirm the option. Press

STOP to clear settings.

D. Press and hold the START button for 3

seconds to charge/discharge.