Dynamite DYN4064 Instrukcja obsługi - Strona 7

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Ładowarka Dynamite DYN4064. Dynamite DYN4064 20 stron. Passport ultra ac/dc charger cycler

Key Beep

Music

10. a) Set Operating Beep Sound (On/Off) or

b) Select Music

Volume Adjust

11. Adjust Volume

Input Volt Low

Cut Off 11.0V

12. Set Detecting Input Low Voltage

Back Light

Brightness 100%

13. Adjust Background Brightness

Load Default

YES/NO ?

14. To reset the charger to Initial Setting

Dynamite Ultra AC/DC Charger/Cycler

While in the User Setup mode, press the dial to

change to Ni-MH battery charging. Press the dial

100%

again to confirm changes.

See the status by turning switch to left/right.

Press the MODE button to adjust the charge

current. Press the START dial and adjust the

current rate to the appropriate rating.

Press and hold the dial for 3 seconds to activate

charge. The charge status and other settings

can be monitored by rotating the dial during fast

charge.

1. Ni-MH Charge Sensitivity

2. Battery Pack Peak Voltage

ni-Mh and ni-Cd Charge Mode

NiMH Charge

4.0A

Message during ni-Mh Charging

NiMH 000 : 01 : 0001

Chg 0.10A 7.62V

NiMH Sensitivity

D.Peak 3mV/Cell

To reset to factory recommended sensitivity,

see Load Default and select "Yes."

Peak Voltage

9.07V